Knowledge Center

Browse Articles

All Posts Project Guides LED Guides Installation Tips Product Spotlights Design Ideas Commercial Lighting Pro Resources

How to Plan Multiple LED Lighting Zones in One Space

Planning LED lighting zones is mostly a design job you do before you buy anything. A zone is a group of lights you want to control together, and thinking in...

What Is a Four-Zone LED Controller and How Does It Work?

A four-zone LED controller lets one remote command up to four separate groups of LED lighting independently, so a single handset can dim the kitchen strip warm while the cabinet...

App-Controlled LED Lighting: Components and Compatibility Requirements

App-controlled LED lighting lets you set color, brightness, and color temperature from your phone through a smart controller wired into the strip. The phone is not the control device on...

Choosing Controls for RGB, RGBW and RGB+CCT LED Strips

When you are choosing RGB, RGBW and RGB+CCT controls, the single rule that governs everything is that the controller must match the strip's channel count. RGB strips use three channels,...

How to Choose a Controller for Your Type of LED Strip

Learning how to choose an LED controller comes down to one habit: read the strip first, then match the controller to it. The controller has to agree with your strip...

Why LED Strip Lights Flicker, Buzz or Shut Off Unexpectedly

When LED strip lights flicker, buzz, or shut off, the cause is almost always a mismatch or a limit somewhere in the system rather than a faulty strip. The most...

Choosing an LED Driver for Dry, Damp and Wet Locations

Choosing an LED driver for the right location means matching the driver's environmental rating to where it will actually sit, not just the strip. A driver built for dry indoor...

Power Injection for LED Strip Lights: When and Why It Is Needed

Power injection is a technique for keeping a long LED strip run bright and even by feeding power to it at more than one point, instead of only at one...

How Wire Gauge Affects LED Strip Brightness and Voltage Drop

Wire gauge affects LED strip brightness because thinner wire has more electrical resistance, and more resistance means more voltage lost between the driver and the strip. That lost voltage shows...

How Far Can an LED Driver Be Located from the LED Strip?

An LED driver can be located a fair distance from the strip, but the low-voltage wiring between them is where distance matters most, because that is the side where voltage...

LED Voltage Drop Explained: Causes, Symptoms and Solutions

LED voltage drop is the gradual loss of voltage along a strip as electrical current travels away from the power feed. The farther the current goes, the more voltage...

Parallel vs Series Wiring for Constant-Voltage LED Strips

For constant-voltage LED strips, the answer is clear: wire multiple runs in parallel, not in series. In a parallel arrangement, every run connects back to the driver and receives the...