How to Add In-Cabinet LED Lighting to Cabinets and Drawers In-cabinet LED lighting puts a small, low-output strip inside your cupboards and drawers so you can actually see what is...
Read More
Toe-kick LED lighting is the low strip of glow that washes out from under your base cabinets and across the floor. It is an accent, not a task light, so...
Read More
Good under-cabinet LED strip lighting turns the counter below your wall cabinets into a bright, even work surface without a glare bulb in your eyes. Plan it as task lighting:...
Read More
Most LED strip installation mistakes trace back to a handful of skipped checks: mismatched voltage, an undersized driver, series wiring where parallel is needed, ignored voltage drop, cutting off the...
Read More
To protect LED strip connections in wet locations, match every part of the system to a stated IP rating for the exposure, seal each join and cable entry, cap the...
Read More
The number of LED connector pins you need matches the number of conductors on your strip, which usually tracks with its color type. As a guide: single-color strips use 2-pin,...
Read More
To make a 90-degree turn with LED strip lights, you have three practical options: use a corner connector that joins two strip ends at a right angle, cut the strip...
Read More
The difference between strip-to-strip vs strip-to-wire connectors comes down to what you are joining. A strip-to-strip connector links two strip sections directly, end to end or around a corner, with...
Read More
Solderless connectors vs soldering comes down to speed and simplicity against durability. For joining LED strips, solderless connectors are fast, need no tools, and handle most do-it-yourself indoor runs, while...
Read More
To cut and reconnect LED strip lights safely, power the strip off first, cut only on the printed cut-point marks, and rejoin the pieces with a compatible solderless connector or...
Read More
There are three common LED strip mounting options: the strip's own adhesive backing, mounting clips screwed to the surface, and an aluminum channel that holds the strip in a track....
Read More
To prepare a surface for LED strip lights, clean it, degrease it, and let it dry fully before the tape ever touches down. The strip's adhesive backing grips best on...
Read More
